Ryobi RY150PWA Manual De Instrucciones página 5

■ Use a garden hose with a maximum length
of 15 m and minimum diameter of 18 mm
(3/4 in).
■ Before each use, ensure that the accessory
is securely attached to the trigger gun.
OVERLOAD PROTECTION
The product has an overload protection device
that is activated when overheating or when a
current spike occurs, automatically shutting
down the power within the product. To resume
operation, disconnect the product from the
power supply, wait for about 15 minutes, and
reconnect the product to the power supply.
TRANSPORTATION AND STORAGE
CAUTION! Mind the weight of the product
when selecting the storage location and during
transportation to prevent accidents or injuries.
■ Stop the product, disconnect from the power
supply, and allow the product to cool down.
Disconnect the product from the water supply
before storing or transporting. Never place
the product in any position other than upright.
■ Clean all foreign materials from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep
the product away from corrosive agents
such as garden chemicals and de-icing
salts. Do not store the product outdoors.
■ Remove water from all hoses and the pump,
and empty the detergent tank before storing
the product.
■ For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
■ Store the product indoors only. Storing the
product in an area with temperature below
0°C will damage the product.
MAINTENANCE
■ Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■ Servicing requires
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre only.
manufacturer's
accessories, and
extreme care and
■ Turn off the product, disconnect from the
power supply and water supply, and allow
the product to cool down:
● before servicing
● before clearing a blockage
● before checking, cleaning, or working on
the product
■ You may make adjustments or repairs
described in this manual. For other repairs,
contact an authorised service centre.
■ Regularly inspect and maintain the high
pressure cleaner for safe operation. RYOBI
recommends inspecting the product every
6 months.
■ Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
KNOW YOUR PRODUCT
See page 147.
1. Rolling support
2. Adapter clip
3. Internal high pressure hose
4. Carry handle
5. High pressure hose
6. Hose reel
7. Reel handle
8. Rotary brush
9. Water inlet filter
10. Nozzle cleaning tool
11. Power cord holder
12. Operator's manual
13. On/off switch
14. Power cord
15. Water inlet port
16. Detergent tank cap
17. Detergent tank
18. Wheel
19. Trigger gun holder
20. Spray angle
21. Spray angle lock
22. Trigger handle lock
23. Trigger
24. Hose lock button
25. Surface cleaner
26. Surface cleaner extension
27. Vario lance
28. Turbo lance
29. Fixed brush
30. Garden hose
31. RYOBI detergent
32. Garden hose connector
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR