Manual Defrost; Cleaning, Care & Maintenance - Polar Refrigeration DN492 Manual De Instrucciones

UK
Resetting Date and Time
To reset the clock data, press and hold the
shown.
1. Press the SET key. The value will start to flash.
2. Adjust the value using both
3. Press the SET key to confirm the new value and move onto the next value.

Manual Defrost

Ensure that no cycle is active and that the hold mode function is not running.
• To manually defrost the appliance: Press and hold the
Note: The defrost will not be done if the temperature detected by the evaporator
probe is higher than the stop defrost temperature parameter.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A POLAR agent or qualified technician must carry out repairs if required.
Stainless Steel Care
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
• Use abrasive Scourers or scrubbing pads, etc.
• Use Chlorinated or acidic detergents
• Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary,
clean them off right away.
• Allow the surface to remain wet.
Do:
• Clean often.
• Use soft Cloths or plastic Scourers.
• Rub with the grain of the metal, rather than across it.
• Use detergents and polish designed for cleaning Stainless Steel.
• Ensure that the cleaning products are washed off fully and that the steel is left dry.
6
DN492-DN493-DN494 _ML_A5_v4_170410.indb 6
key for 5 seconds. The date and time parameters will be
and keys.
key for few seconds to begin the process.
2017/4/10 11:12