Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
3.
Open the door and carefully insert the laundry into the drum.
4.
Close the door.
5.
Press the "Start/Pause" button.
Warning:
Do not perform the Reload operation if the water level or temperature are high.
6. CLEANING AND MAINTENANCE
Warning:
Always switch off the machine and close the water inlet tap before cleaning or maintenance.
Cleaning the main body. Fig. 22
Proper maintenance can extend the device's lifespan. When necessary, you can clean the
washing machine's surface with a soft, dry cloth or by using a small amount of neutral,
non-abrasive detergent diluted with water. If water leaks or overflows, use a cloth to wipe it
up and absorb the water immediately. Never use sharp objects to remove encrusted dirt.
Warning:
Never use abrasive or caustic agents, formic acids, or diluted solvents or similar substances
such as alcohol.
Cleaning the drum
-
Rust stains that may appear inside the drum due to the presence of metal objects should
be cleaned as soon as possible using a non-chlorine detergent.
-
Never use steel wool or similar items to clean the drum.
Please note
Keep the laundry away from the washing machine while cleaning the drum.
Cleaning the door.
Fig. 23
-
It is advisable to clean both the glass and the plastic door seal after each washing cycle.
-
Remove accumulated lint, stains, or dirt to prevent possible leaks.
-
Remove any objects that may have been caught in the seal, such as coins, buttons, etc.
-
Use a soft cloth for cleaning.
Cleaning the inlet filter.
Fig. 24
1.
Close the water inlet tap and remove the water supply hose.
2.
Clean the filter with a soft brush.
3.
Loosen the water supply hose from the rear part of the washing machine. Remove the
B O LE R O D RESSCO DE 1210 0 0 A
70
filter using a pair of tweezers or long-nosed, non-cutting pliers.
4.
Use a soft brush to clean the filter.
5.
Reinstall the filter in the water inlet and connect the hose.
6.
It is advisable to clean the inlet filter every 3 months to ensure the proper operation of
the washing machine.
Note:
Decreasing water flow indicated that the filter must be cleaned.
Cleaning the detergent
tank. Fig. 25
1.
Open the tank and press down the release mechanism of the softener plastic cover. Pull
the tank out of its housing. Clean the inside of the housing with a brush.
2.
Lift the softener cover off the detergent tank and wash both items with warm, detergent-
free water
3.
Replace the softener cover and push the whole assembly back into place.
Note:
-
Do not use abrasive or caustic agents to wash plastic parts.
-
Cleaning is recommended every 3 months to ensure a normal operation of the washing
machine.
Cleaning the drain pump filter.
Fig. 26
1.
Open the lower front cover.
2.
Remove the filter by turning it counterclockwise.
3.
Remove any objects that may have accumulated inside, such as buttons, coins, etc.
4.
Replace the filter by turning it clockwise and close the cover.
Warning:
When the equipment is in use and depending on the selected programme, the pump may
contain hot water. Never open the drain pump cover during a washing cycle. Always wait until
the cycle is finished and the water has been drained. Make sure that filter is fitted properly.
ENGLISH
BOLERO DRES SCODE 1 21000 A
71
Publicidad
