Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical connection
WARNING
Risk of electric shock and fire if electrical
connection is not installed properly!
Plug into a fixed, grounded 3-prong outlet only. The
outlet must be installed and grounded according to
code by a qualified electrician. If necessary, have
the installation inspected by a qualified technician
to ensure it is properly grounded.
Never remove grounding conductor.
Do not use an extension cord, adapters or power
strip.
Non-compliance with these instructions may result
in death, fire or an electric shock. Improper
connection of the grounding conductor may result
in an electric shock. If you are in doubt whether the
appliance has been grounded properly, have the
appliance tested by a qualified electrician.
The receptacle must be installed according to the
Installation Manual.
Connect the appliance to 115 V/60 Hz AC through a
correctly installed 3-pole grounded receptacle. The
receptacle must be protected with a 10 to 16 A fuse.
The appliance comes with a UL registered 3-wire
Power Cord.
Please see the following table:
Appliance
Maximum simultaneous load
Fridge-freezer
6.0 amps
Check on the Rating Plate whether the indicated
voltage and current type correspond with the values of
your power supply. The location of the Rating Plate
can be found in the chapter "Customer Service".
WARNING
Never connect the appliance to electronic energy
saving devices.
Our appliances can be used with power line and
sine-controlled inverters. Power line-controlled
inverters are used for photovoltaic systems which
are connected directly to the national grid.
Sine-controlled inverters must be used for isolated
applications (e.g. on ships or in mountain lodges)
which are not connected directly to the national
grid.
Installing the handles
Storage door handle
1. Take the cold storage door handle out of the box
and place it as per the direction shown in the figure
(Note: i.e. the direction which both screw holes on
the handle are close to the edge) and hang the
handle above the set bolt.
2. Use the small hexagon wrench supplied in the box
to set the handle screws into both the small
screwed holes on the handle. After they are
screwed down, gently shake the handle to confirm
the handle is tightened.
Instructions for installation of cold storage door handle
Difference between the chilling and refrigeration
handle:
Lie them flat, the one with higher chordal height is the
refrigeration handle.
Refrigeration door handle
The assembly steps of the refrigeration door handle
are the same as the ones of the cold storage door
handle. During the assembly of the handle the
direction of tapping hole is downward (to the ground).
en-us
9
Publicidad
