Methods Of Operation; Changing The Exhaust Direction - Hitachi Koki NT 50AE Manual De Instrucciones E Instrucciones De Seguridad

English

METHODS OF OPERATION

This Nailer is equipped with the push lever and does not operate unless the push lever is
depressed (upward position).
There are two methods of operation to drive nails with this Nailer.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever fire):
(1) Intermittent operation (Trigger fire)
1 Position the nail outlet on the workpiece
with finger off the trigger.
2 Depress the push lever firmly until it is
completely depressed.
3 Pull the trigger to drive a nail.
4 Remove finger from the trigger.
To drive another nail, move the Nailer along
the workpiece and repeat this procedure.
(2) Continuous operation (Push lever fire)
1 Pull the trigger with the Nailer off the
workpiece.
2 Depress the push lever against the
workpiece to drive a nail.
3 Move the Nailer along the workpiece with
a bouncing motion.
Each depression of the push lever will drive
a nail.
As soon as the desired number of nails have
been driven, remove finger from the trigger.
NOTE:
● After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 2 – 3 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer;
and
4) open the petcock on the air compressor tank to drain any moisture.

CHANGING THE EXHAUST DIRECTION

The direction of the exhaust vent can be
changed by turning the top cover.
18
Push
Lever
Trigger
Previously
pull the
trigger
Top Cover
Exhaust
Vent