Parkside PKM 103 A1 Traduccion Del Manual De Instrucciones Originale página 14

GB IE
Setting the working
height
Adjust the working height of the device to
the surface you are working on. For asphalt
or plaster, select a lower working height
(brushes close to the ground). For lawns,
select a higher working height (brushes ad-
justed to the height of the lawn).
1. Loosen the adjusting screw (5).
2. Set the desired working height.
3. Tighten the adjusting screw.
Emptying the collection
container
1. Hold the collection container (3) at the
grip bar ( 15).
2. Lift it out from between the lower bars.
3. Empty the collection container.
4. Re-attach the collection container onto
the device.
Replacing the
brushes
1. Pull the four brushes (17) towards the
centre and out of the holder.
2. Slide the brushes (17) into the holder.
Maintenance
Only use original parts.
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Replace damaged
parts.
14
Cleaning
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice. Never clean the device under
running water.
• Clean the surfaces thoroughly after
each use with a soft brush, paintbrush
or cloth.
• Turn the device over and clean the
brushes (17).
Storage
• Store the device in a dry and dustproof
location and out of reach of children.
Storing the device space effi ciently
To store the device space effi ciently, fold
the handle in.
1. Loosen the wing nuts (7) on the lower
bars (2).
2. Fold the handlebar (1) onto the lower
bars (2).
Transport
Warning: Fold up the device handle before
transporting it.