Gardena AquaClean 24/18V P4A Instrucciones De Empleo página 7

(17)
1. Clean the airflow slots with a soft brush (do not use a screwdriver).
2. Clean all movable parts after each operation. Especially remove any
dirt from the connections.
(7)
3. Unscrew the connection
size 17).
4. Remove the device filter (18)
under running water.
5. Remove the spray lance (1)
water.
(12)
6. Remove the suction filter
7. Screw the connection (7) hand-tight into the washer.
To clean the battery and the battery charger:
Make sure that the surface and the contacts of the battery and the battery
charger always are clean and dry before you connect the battery charger.
Do not use running water.
v Battery charger: Clean the contacts and the plastic parts with a soft
and dry cloth.
v Battery: Occasionally clean the ventilation slots and the terminals on
the battery using a soft brush that is clean and dry.
5. STORAGE
To put into storage:
The product must be stored away from children.
1. Remove the battery.
2. Charge the battery.
3. Clean the washer, the battery and the battery charger
(see 4. MAINTENANCE).
4. Store the washer, the battery and the battery charger in a dry,
enclosed and frost-free place.
Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
Disposal of the battery:
The GARDENA battery contains lithium-ion cells that should not
be disposed of with normal household waste at the end of its life.
Li-ion
IMPORTANT!
v Dispose of the batteries through or via your municipal recycling
collection centre.
1. Discharge the lithium-ion cells completely (contact the GARDENA
Service).
2. Protect the contacts on the lithium-ion cells against short circuits.
3. Dispose of the lithium-ion cells properly.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Eye injury and personal injury caused by high pressure
water jet.
v Remove the battery before you troubleshoot the product.
Problem Possible Cause
Washer conveys no
Water container is empty.
or almost no water
Air is in the system.
Air is in the system.
GAR_14800-56.960.02_2024-03-08.indd 7 GAR_14800-56.960.02_2024-03-08.indd 7
(if necessary using a spanner with spanner
from the connection (7) and clean the filter
and rinse the spray lance (1) with clear
(12)
and clean the suction filter .
Remedy
v Fill the water container.
v Remove the lance and push
the start lever for about
30 seconds until water is
visibly pumped.
Reassemble the lance.
v Ventilate the system at low
altitude. Then move to the
working position.
Problem Possible Cause
Washer conveys no Device filter
or almost no water (see 4. MAINTENANCE), suction
filter or nozzle is clogged.
Pressure drop during Device filter or suction filter
operation
is dirty.
Battery charge level is too low. v Charge the battery.
Water is badly sucked Suction height too high.
in from the water tank
Air is in the system.
Device filter or suction filter
is dirty.
Washer does not stop Start lever is stuck.
Washer does not start Battery is empty.
or stops.
(L1)
LED is flashing green
[ Fig. O4 ]
Washer does not start Battery temperature is outside
or stops.
the permissible temperature
(Wp)
Error-LED is illuminated range.
red [ Fig. O4 ]
Washer is overheated
(e. g. by direct sunlight).
Water has entered the battery. v Allow the battery to dry in
There are drops of water or
moisture between the battery
contacts on the washer.
Engine is blocked.
Nozzle is partially or
completely clogged.
Washer does not start Product is defective.
or stops.
Error-LED (Wp) is flashing red
[ Fig. O4 ]
Washer does not start Battery is not put completely
or stops. into the battery holder.
Error-LED (Wp) is not
illuminated [ Fig. O4 ]
Battery is defective.
Product is defective.
Charging is not possible. The battery is not connected
Battery charge indicator (Lc)
(correctly).
is continuously illuminated
Battery contacts are dirty.
[ Fig. O3 ]
Battery temperature is out-
side the permissible charging
temperature range.
Battery is defective.
(Lc)
Battery charge indicator Mains plug of the charger is
is not illuminated [ Fig. O3 ] not (correctly) plugged in.
Socket outlet, mains cable or
charger is defective.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.
7. TECHNICAL DATA
Battery Medium Pressure
Unit Value (Art. 14800)
Washer
Rated pressure /
MPa 2.4
Max. pressure
Remedy
v Clean the device filter and
suction filter. Clean the
nozzles e. g. with a needle.
v Clean the device filter
and suction filter
(see 4. MAINTENANCE).
v Reduce the suction height.
v Remove the lance and push
the start lever for about
30 seconds until water is
visibly pumped.
Reassemble the lance.
v Clean the device filter
and suction filter
(see 4. MAINTENANCE).
v Remove the battery and
loosen the start lever.
v Charge the battery.
v Wait until the battery
temperature is between
0 °C and + 45 °C again.
v Let the washer cool down in
a cool, shady place.
a protected place.
v Remove the water drops /
moisture with a dry cloth.
v Contact the GARDENA
Service.
v Clean the nozzle e. g. with
a needle or wire.
v Contact the GARDENA
Service.
v Put the battery completely
into the battery holder until
it audibly engages.
v Replace the battery.
v Contact the GARDENA
Service.
v Connect the battery to
charger correctly.
v Clean the battery contacts
(e. g. by connecting and
disconnecting the battery
several times. Replace the
battery if necessary.
v Wait until the battery
temperature is between
0 °C and + 45 °C again.
v Replace the battery.
v Insert the mains plug into the
mains socket (completely).
v Check the mains voltage.
Let the charger be checked
if necessary by an author-
ised specialist dealer or the
GARDENA Service.
7
08.03.24 08:23 08.03.24 08:23