Publicidad
Idiomas disponibles
Idiomas disponibles
VDV Wire Tester / English
10. Indicates wiring error on cable being tested.
11. Appears when the tone generator is activated.
12. Indicates that two or more wires are shorted to each other.
13. Flashes when the tester is connected to a cable with voltage on it, exposure to
voltage can damage the tester, if this warning appears, immediately disconnect the
cable from the tester.
14. Appears when one or more pairs are open.
15. Indicates low battery, when this symbol appears, results from the tester may not be
reliable and the battery should be replaced immediately.
16. Appears when the tester detects a Remote ID, the number that appears corresponds
to the number on the Remote ID.
17. Appears when the tester detects the signal is split between two or more pairs.
1
2
4
5
6
7
8
9
4
3
10
11
12
13
14
15
16
17
4. Operation
4-1.Voice
WARNING: Exposure to voltage can damage the tester, immediately disconnect the
cable under test if the Voltage warning appears on the display. Make sure the cable is
not connected to any device that can supply voltage before retesting. Do not connect
two different cables into the Voice (RJ11/12) and Data (RJ45) test ports at the same
time. The cables will interact with each other and alter test results.
1. Press ON/OFF
Button to turn on the tester and then press Voice
select the voice wire test function.
2. Connect one end the cable under test to the RJ11/RJ12 port on the tester.
3. Connect the other end of the cable under test to the RJ11/RJ12 port on the remote.
4. Interpret the results using the wiring and display examples on Page 13.
Note: Split may appear on the display when testing cables that have no twisting on the
pairs.
VDV Wire Tester / English
Button to
Remote
5
Publicidad
