Levenhuk Wezzer PRO LP300 Guia Del Usuario página 10

Once synchronized, simulate wind and rain by rotating the anemometer cups and dripping water into the rain
gauge.
When the connection is established, place the multisensor and console in their permanent places.
Screen setup
Most users won't need to change the basic weather station settings other than relative barometric pressure. If
you need to make changes, simply tap the desired area on the tap screen. You can interrupt the setting at any
time by tapping any area other than the tap buttons (11).
Indoor temperature
Tap the IN TEMP (Indoor temperature) area of the screen to set the indoor temperature parameters.
At first tap, the + and − buttons will flash. Tap them to switch between Celsius (°C) and Fahrenheit (°F).
When tapped again, the HI AL (High Temperature Alert) icon will light up. Use + or − buttons to set the upper
threshold. Hold the buttons to change the value faster. Use the ON/OFF button to turn alerts on or off.
The third time you tap it, the LO AL (Low Temperature Alert) icon will light up. Set the lower threshold and
turn alerts on or off in the same way.
The fourth tap will display the maximum recorded room temperature. The numbers will start flashing and the
MAX icon will light up. Hold flashing value for 3 seconds to reset to the current reading.
The fifth tap will display the minimum recorded room temperature. The numbers will start flashing and the
MIN icon will light up. Hold flashing value for 3 seconds to reset.
Outdoor temperature
Tap the OUT TEMP (Outdoor temperature) screen area to adjust the outdoor temperature settings.
At first tap, the + and − buttons will flash. Use them to switch between displaying the outdoor temperature,
wind chill index, and dew point.
When you tap it again, select the unit of measurement: Celsius (°C) or Fahrenheit (°F).
The third time you tap it, the HI AL (High Temperature Alert) icon will light up. Use the + or − buttons to set
the upper threshold. Hold the buttons to change the value faster. Use the ON/OFF button to turn alerts on
or off.
The fourth time you tap it, the LO AL (Low Temperature Alert) icon will light up. Set the lower threshold and
turn alerts on or off in the same way.
The fifth tap will display the maximum recorded outdoor temperature. The numbers will start flashing and the
MAX icon will light up. Hold the flashing value for 3 seconds to reset to current reading.
The sixth tap will display the minimum recorded outdoor temperature. The numbers will start flashing and the
MIN icon will light up. Hold the flashing value for 3 seconds to reset.
10