Levenhuk Wezzer PRO LP300 Guia Del Usuario página 11

Indoor humidity
Tap the IN HUMIDITY (Indoor humidity) screen area to set the indoor humidity parameters.
At first tap, the HI AL (High Humidity Alert) icon will light up. Use the + or − buttons to set the upper
threshold. Use the ON/OFF button to turn the alerts on or off.
The second tap will illuminate the LO AL (Low Humidity Alert) icon. Set the lower threshold and turn alerts on
or off in the same way.
The third tap will display the maximum recorded indoor humidity value. The numbers will start flashing and
the MAX icon will light up. Hold the flashing value for 3 seconds to reset to current reading.
The fourth tap will display the minimum recorded room humidity. The numbers will start flashing and the MIN
icon will light up. Hold the flashing value for 3 seconds to reset.
Outdoor humidity
Tap the OUT HUMIDITY (Outdoor humidity) screen area to access the outdoor parameters. The order of the
settings is the same as in the previous section (including the setting thresholds and displaying the maximum
and minimum recorded values).
Wind speed
Tap the WIND area of the screen to set the wind speed parameters.
At first tap, the + and − buttons will flash. Use them to switch between displaying the average wind speed and
wind gust speed.
Tap again to select the units of measurement: km/h, mph, m/s, knots, or Beaufort rating (bft).
The third time you tap it, the HI AL (High Wind Alert) icon will light up. Use the + or − buttons to set the upper
threshold. Hold the buttons to change the value faster. Use the ON/OFF button to turn alerts on or off.
With the fourth tap, set the wind direction alert. The direction arrow will start flashing. Use the + or − buttons
to set the direction. Turn notifications on/off using the ON/OFF button.
The fifth tap will display the maximum recorded wind speed. The numbers will start flashing and the MAX icon
will light up. Hold the flashing value for 3 seconds to reset to current reading.
Precipitation
Tap the RAIN (Precipitation) area of the screen to adjust the precipitation settings.
At first tap, the + and − buttons will flash. With their help, choose to display the amount of precipitation for
one hour, day, week, month, or all the time.
When you tap again, select the unit of measurement: mm or inches.
11