Jimmy PW11 Pro Max Manual De Instrucciones página 8

Charging base assembly
Press charging base upper towards charging base lower
as the picture show. After a "click" sound is heard and
clips are located in corresponding holes, the assembly is
completed. (Fig 5)
Machine charging and placement
Place the floorhead in upright position, lift the machine,
align the charging slot at the rear of the machine with the
charging socket on the charging base, and gently place
down the machine into the charging base; To take out the
machine, hold the handheld vacuum handle and directly
pull the machine out of the charging base. (Fig 6)
Clean water tank assembly and
disassembly
To remove clean water tank, hold the clean water tank
handle and pull it upward to remove the clean water tank.
To install clean water tank, place it on floorhead and press
down until a "click" sound is heard. (Fig 7)
Brushroll assembly and disassembly
To remove the brushroll,remove clean water tank first,
and then press floorhead with one hand, rotate the
brushroll end cap upwards with another hand, and
remove brushroll outwards; When installing the brushroll,
first align one end of the brushroll with the spline, rotate
it inward to the bottom, and then rotate the brushroll end
cap in another end of brushroll to lock the brushroll. (Fig 8)
Assembly and disassembly of metal
tube and carpet brush
By assembling handheld vacuum cleaner, metal brush
and carpet brushroll together, the product can be used as
a cordless stick vacuum cleaner. When assembling metal
tube, align metal tube connector with handheld vacuum
mouth and push toward the vacuum until a "click" sound
is heard. To remove metal tube, press release button
and pull metal tube. Assembly and disassembly of carpet
brush is the same. (Fig 9)
Assembly of accessory holder and accessories
When assembling accessory holder, insert holder tube connector into accessory holder connector vertical and
push downward until a "click" sound is heard. Put the accessories on to the holder in correct position indicated
in the picture. (Fig 10)
6
Charging base
upper
Charging base
5
lower
Clean water
tank handle
7
8
9
6
Spline
10