Chapter 2 Use of the Product
Note: Before use, please check whether the machine has power, if no power, please fully charge the machine
before using it.
LED screen and instructions
Lights indicater
Battery power
Dirty water
tank full indicator
Self cleaning
indicator
Use of stick vacuum and washer
In the upright tilt state, press the on/off button and product
start to work. Default mode is in Auto mode, press the
mode button to switch among floor mode, carpet mode
and Auto mode, accompanied by voice reminding. Press
the on/off button again, the voice reminds "Machine
turning off", the main motor will run for 2 seconds, the
machine stops working. (Fig 11)
In Auto mode, the machine power changes automatically
basing on how much dirty water or dust is detected. And
LED light colour changes accordingly. The more dirty
water or dust is detected, the more red lights. And the
less dirty water or dust is detected, the more blue lights.
Notes:
1. When cleaning carpet, please clean the floorhead
first (refer to "Cleaning and Maintenance, Floorhead
Cleaning" for details) and to deep clean carpet it is
recommended to replace the carpet brush. (Carpet brush
can be selected according to your own needs and sold at
JIMMY distributors)
2. When the battery level is lower than 20%, it cannot be
switched to Carpet mode.
When upright vacuum cleaner is working, press the water spray button, the auto water spray function is
open by default. LED screen will show auto spray indicator and clean water will be sprayed to brushroll
automatically. To turn off auto water spray function, keep pressing the self cleaning button for over 3 seconds
when product is on. To turn on auto water spray function again, keep pressing the self cleaning button for over
3 seconds when product is on.(Fig 12)
Air path blockage
indicator
11
12
Mode display
Battery power icon
Brushroll drying indicator
Clean water tank
empty indicator
Auto water spray indicator
self-cleaning button
7