Publicidad
Idiomas disponibles
Idiomas disponibles
4. When the internal battery is fully charged, the charger will automatically go into maintain mode and
maintain the battery at full charge without damaging it. When in maintain mode, the GREEN LED will
light, as long as there is an AC cord connected to the charging port.
5. Charge the jump starter as soon as possible after use.
CHARGING THE INTERNAL BATTERY WHILE DRIVING
4.3
You may also charge the internal battery while driving, using a male-to-male charger cable (part number
94500109 – not included).
IMPORTANT: DO NOT CHARGE INTERNAL BATTERY FOR MORE THAN 30 MINUTES OR LEAVE THE
BATTERY UNATTENDED. IT COULD EXPLODE, CAUSING PROPERTY DAMAGE OR PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory cable into the 12V DC power outlet.
3. Insert the other end of the accessory cable into the vehicle's accessory outlet (lighter socket).
NOTE: The RED LED does not operate during this method of charging. Using this method to charge the
battery overrides the maintain mode and the battery can be overcharged.
4. Monitor the progress of the charge by pressing the Battery Status button on the front of the unit. When
the battery is fully charged, disconnect the accessory cable from the unit, and then from the lighter
socket of the vehicle.
NOTE: Completely disconnect the charger cable when the engine is not running.
5.
OPERATING INSTRUCTIONS
JUMP STARTING A VEHICLE
5.1
IMPORTANT: Using the Engine Start feature without a battery installed in the vehicle will damage the
vehicle's electrical system.
1. Turn the ignition OFF.
2. Lay the DC cables away from any fan blades, belts, pulleys and other moving parts.
3. For a negative-ground vehicle (as in most vehicles), connect the Instant Power's POSITIVE (RED)
clamp to the POSITIVE (POS, P, +) battery post. Next, connect the NEGATIVE (BLACK) clamp to the
vehicle chassis or engine block, away from the battery.
4. For a positive-ground vehicle, connect the Instant Power's NEGATIVE (BLACK) clamp to the
NEGATIVE (NEG, N, -) battery post. Next, connect the POSITIVE (RED) clamp to the vehicle chassis
or engine block away from the battery.
5. Turn the switch to the ON position
6. Crank the engine for no more than 8 seconds. If the engine does not start, wait 2 minutes before
cranking again.
7. After the engine starts, turn the switch to the OFF position and remove the unit from the battery.
8. Charge the unit.
USING THE USB PORT
5.2
The USB port provides up to 2A at 5V DC.
1. Ensure the battery clamps are securely clipped on the storage holders.
2. Turn the unit ON.
3. Plug your device into the USB port.
4. When finished using the USB port, turn the switch to the OFF position.
5. Charge the unit.
USING THE WORK LIGHT
5.3
The work light is controlled by a sliding ON/OFF switch located on the front of the unit.
• Make sure the lamp is turned OFF when the unit is being recharged or stored.
• Position the unit on a flat, stable surface near the intended work area.
• Ensure the battery clamps are securely clipped on the storage holders.
• 7 •
Publicidad
