Descargar Imprimir esta página

Sears Kenmore 25359682992 Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

This Owner's Guide provides specific o perating instructions
foryourmodel U se therefrigerator only asinstructed in
thisOwner's G uide, Before starting therefrigerator,
followtheseimportant firststeps.
LOCATION
.
Choose a place that is near a grounded electrical
outlet
Do Not use an extension cord or an adapter
plug,
ff possible,
place the refrigerator
out of direct sunlight
and away from the range, dishwasher
or other heat
sources
• The refrigerator
must be installed on a floor that is
level and strong endugh to support a fully loaded
refrigerator
-
Consider water supply availability
for models equipped
with an automatic ice maker.
INSTALLATION
-
Do not install the refrigerator where lemperature
will
drop
below 60°F (15°C) or rise above 110°F (43°C),
The compressor
will not be able to maintain proper
temperatures
In a recessed installation,
allow an extra 1/2 inch
(10-15 ram) on each side, for ease of installation
-
To permit proper door swing, if the hinge side of the unit
will be placed against a walt, allow a 1- 3/4 inch
(44 ram) space between the wall and the refrigerator
DOOR
OPENING
For best use of drawers and freezer basket, refrigerator
should be in a position where both refrigerator and freezer
doors can be opened about 135 _
LEVELING
Refrigerator
must be leveled with all bottom corners
resting firmly on a solid floor Adjust front rollers to
level cabinet both front-to-rear
and side-to-side
Keep
cabinet as low as possible for stability
Never adjust
cabinet
rollers
so front is lower than rear.
° To adjust
front
rollers:
Open refrigerator
and Ireezer
doors
Remove toe grille by pulling it straight out
Adjust roliers by turning each roller adjusting
bolt with
an adjustable
wrench, a socket wrench, or a nutdriver
until the refrigerator
is level and stable
Rear rollers
are not adjustable.
.
Check both doors to ensure the seals touch the
cabinet evenly on all four corners
• If freezer door is higher than refrigerator door,
raise right corner and/or lower left corner until doors
align across top of cabinet,
If refrigerator door is higher than freezer door,
raise left corner and/or lower right corner untiI doors
at}gn across top of cabinet°
Ro!_er Adiu_ng Bolt
Adiust_ng Front Rot_ets
R_pla=n9 Tc_ G_3b
- To replace toe grille:
Line up tabs with holes, and
push grille straight on.
CLEANING
.
Wash the inside, all removable
parts, and theoutside
with mild detergent and warm water
Wipe dry, Do Not
use harsh cleaners on these surfaces.
Do not use razor blades or other sharp instruments
that can scratch appliance
surface, when removing
adhe siva labels. Any glue teft from tape or energy tabor
can be removed with a mixture of warm water and mild
detergent, or touch
residue with sticky side of tape
already removed
• Do not remove the Serial
Plate.

Publicidad

loading

Este manual también es adecuado para:

Kenmore 25359682994