Orbegozo DS 58190 B IN Manual De Instrucciones página 13

DS 58190 B IN
• Exhaust air should not be sent by conductors used to
evacuate fumes from equipment powered by gas or
other fuel.
• The minimum distance between elements of cooking and
the bottom of the hood must be at least 65cm if the
hood is installed on a gas cooking element. If the
instructions for installation of gas cooking element to
indicate a greater distance, should be taken into account.
The distance of 65cm cannot be reduced.
• The regulations regarding air evacuation must be
respected.
NOTICE
1. Thank you for choosing our cooker hood. Please read the instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and competent fitter.
3. The manufacturer disclaims all liability for any damage or injury caused as a result of not following
instructions for installation contained in the following text.
The cooker hood is used on 220/240v, 50Hz.
FEATURE
1. The cooker hood uses high quality materials, and is made with a modern design.
2. Equipped with a large power low noise electric motor and centrifugal leaf, it produces strong suction, low
noise, non stick grease filter and easy to clean.
3. Special wind tunnel construction and oil collector design, free dirt will be absorbed in a second.
INSTALLATION
1 For optimum performance the extractor hood should be installed
approximately 65-75 cm above the ho
2 The hood is supplied with screws and rawlplugs which are suitable for most
types of wall and ceiling. However it is advisable to consult a qualified
technician to ensure that the materials are right for your wall or ceiling. The
wall or ceiling must be strong enough to support the weight of the hood.
3 Electrical connection: The mains current must match the current stated on the characteristics label
situated inside the Hood. If the plug included is correct, connect the hood to a socket which meets safety
13