Teka DVT Vr.01 Manual De Instrucciones página 12

Filter saturation indicator "F"
When the sign 'Saturation of the filters'
is on, the filters should be cleaned.
After cleaning the filters, simultaneously
push "+" and "­" for at least 3 seconds
whereupon the sign will be switched
off.
Cleaning and maintenance
During cleaning and maintenance
work, make
instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of
stainless steel, use proprietary cleaners
mentioned in the product instructions.
• If your kitchen hood is painted, use
lukewarm water and a neutral soap.
• Never use metallic scourers, nor
abrasive or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• Do not use vapour cleaners
sure the safety
Cleaning the metal filters
• To remove the filters from their fittings,
press lightly on the locks and then pull
them off.
• The metal filters can be cleaned by
soaking them in hot water with neutral
detergent until the fat dissolves and
then rinsing them under the tap or using
special anti­grease products. They can
also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick
to them.
• Cleaning in a dishwasher may damage
the metallic surface (blackening it),
although this will not affect its fat
retention capacity.
• Once clean, leave them to dry off and
then fit them onto the kitchen hood.
Changing light bulbs
Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp.
• Screw the lamp cover back in.