Krups EVIDENCE CLASSIC EA89 Serie Guia De Inicio Rapido página 26

3. Steam escapes from the grid of the drip tray.
Depending on the type of preparation, steam may escape from the grid of the drip tray.
4. Steam appears under the bean tray lid.
Check that the cleaning tablet hatch located under the lid (L) is properly closed.
MAINTENANCE
1. The machine does not request descaling.
The descaling cycle is requested from a large number of milky drink preparations or hot water. If you only consume
coffee, descaling will not be required often.
2. Some grounds are in the drip tray.
A small amount of ground coffee can get into the drip tray. The machine is designed to evacuate any excess ground
coffee so that the percolation zone remains clean.
3. The intuitive indicator light is still on after you have emptied the coffee grounds tray.
Reinstall the coffee grounds tray.
4. After filling the water tank, the intuitive indicator light stays on.
Check the correct positioning of the tank in the appliance.
The floats at the bottom of the tank must move freely. Check and unlock the floats if necessary.
DRINKS
1. The coffee is pouring too slowly.
Turn the "fineness of grinding" button to the right to obtain a coarser ground coffee (this may depend on the type of
coffee used).
Perform one or several rinsing cycles.
Change the Claris Aqua Filter System cartridge.
2. The coffee is too light or not full-bodied enough.
Check that the bean container contains coffee and that it is moving down correctly.
Avoid the use of oily, caramelised or flavoured coffees which may not be captured properly.
Decrease the volume of the preparation and increase the strength of the preparation using the coffee strength function. Turn
the "fineness of grinding" button to obtain a finer ground coffee. Make your drink in two cycles using the 2-cup function.
3. The espresso or the coffee is not hot enough.
Increase the temperature of the coffee in the machine's settings. Heat the cup by rinsing with hot water before starting
to prepare the drink.
Before making your coffee, carry out a rinse of the coffee circuit. A coffee rinsing function when switching on the
appliance can be activated in settings / auto rinsing
4. Clear water is running from the coffee nozzles before each coffee.
A pre-infusion takes place when you start a recipe, and this can lead to a small amount of water coming out of the
coffee nozzles.
If one of the problems outlined above persists, contact KRUPS Consumer Service.
ELIMINATION
Some appliances contain a battery that is only accessible by a repairer for safety reasons. To replace the batteries,
contact your nearest service centre.
Important: Your appliance contains a number of materials that can be reused or recycled. We participate in the
protection of the environment! Leave it at a collection point for processing.
GUARANTEE
The guarantee does not apply in the following cases:
- Presence of foreign bodies in the grinder,
- Ground coffee has been poured into the bean container,
- The Claris - Aqua Filter System filter cartridge is not used according to KRUPS instructions,
- In the event of lack of descaling, cleaning or regular maintenance.
Any work on the appliance must be carried out by an authorised KRUPS centre.
This Espresso Automatic coffee/espresso machine must only be used for the preparation of coffee, hot water or to
froth milk.
Manufacturer: GSM – 1076 Rue Saint-Léonard 53100 Mayenne - France
46