Baker Hughes Druck ADTS542F Manual De Instrucciones página 104

Capítulo 6. Localización de averías y pruebas
Número de error Descripción
76 Abort Detected
77 ABORT INSTIGATED
78 ADC7822 Invalid Input
79 Calibration switch in ON position when commanded OFF
80 Calibration switch in OFF position when commanded ON
81 Calibration Latch indicates invalid inputs
82 ALTERA Event
83 ALTERA HISR Failed
84 ALTERA LISR Failed
85 ALTERA is not present or not responding
86 Application code FLASH is not blank
87 BIT Clear Byte
88 BIT Clear Word
89 BIT Get Byte
90 BIT get Word
91 BIT Set Byte
92 BIT Set Word
93 BOOT FLASH is not blank
94 Buzzer Timer Fail
95 Invalid CAN Task Arbitration
96 Invalid CAN Task Device ID
97 Invalid CAN Task RX
98 CAN Task Send Fail
99 Invalid CAN Task SPI Read
100 Invalid CAN Task SPI Write
101 CAN controller is not present or not responding
102 CAN Loopback using test remote device has failed
103 CAN test transmission has failed
104 No CAN Response from remote board
105 CAN Task Buffer Full
106 CAN Task HISR Fail
107 CAN Task LISR Fail
108 CAN Task Memory fail
109 CAN Task Queue Fail
110 CAN Task task Fail
111 Data FLASH is not blank
Copyright 2014 Baker Hughes Company.
92 | Manual de instrucciones del ADTS542F/552F/553F/554F–Español
Tabla 6-1: Códigos de error (Continuación)