Impecca RA-2180 Guia Del Usuario página 8

4. With both hands, open the door
beyond a 90-degree angle, lift it up,
and carefully remove it.
5. Loosen the two screws (G) located at
the bottom right of the freezer door.
Remove the right stopper block (H)
and the right door stopper (I). Then,
install the left stopper block (K) and
the left door stopper (J) provided in
a plastic bag.
6. Open the fridge door, then use a
4mm Allen Wrench (included in
the plastic bag) to loosen the two
screws (L) and remove the middle
hinge (M). Keep the middle hinge
(M) for future use. Remove the
fridge door from the lower hinge.
7. Place the fridge door on a smooth
surface with its panel facing up-
ward. Loosen the two screws (G) on
the right bottom of the fridge door.
Remove the right stopper block (H)
and the right door stopper block (I).
Then, install the left stopper block
(K) and the left door stopper (J).
8. Switch the screw hole covers and
screws on the middle cover plate
from left to right.
9. Lay the refrigerator on soft foam
packaging or a similar material. Re-
move both adjustable bottom feet
parts and the lower hinge part by un-
screwing the special flange self-tap-
ping screws. Loosen the lower hinge
axis, then install it in the reverse
hole site.
8