31
30
29
Fig. Remote control
. Assembling the appliance
NOTICE!
Possibility of damage to the appliance!
Without a fixed base, the fan may tilt and fall over.
Do not use the fan until it is fully assembled.
You need a Phillips screwdriver.
Unscrew the safety screw of the base (9) from the lower column (11).
Insert the lower column into the recess in the base (10) and screw in the safety
screw of the base until it is hand-tight.
Remove the safety screw from the upper column (13) using a Phillips screwdriver.
Insert the upper and lower columns into each other and secure the two parts
again with the safety screw.
Remove the lock nuts for the rotor (6) and for the rear safety grille (4).
26. On/Off button
27. Operating mode selection button
26
28. Increase
fan speed
29. Set the timer
27
30. Reduce
fan speed
28
31. Oscillation button
DE
FR
NL
ES
IT
EN
125