Hofmann monty 3550 Manual De Operador página 15

3.0-3
1062.tif
4,5 bar
2
1 3
3.0-4
F.
Press bead seater/infl ator pedal on left side of the machine
down (1, Fig. 3.0-3): air will come from infl ation hose end.
Only for Tubeless wheel models:
F1. Press bead seater/infl ator pedal (1, Fig. 3.0-3) on
left side of the machine half way down: air will come from
infl ation hose end only (2, Fig. 3.0-3).
F2. Press bead-seater pedal down swiftly to get air blast
from the infl ator jets. Air simultaneously comes out of
infl ator hose (2, Fig. 3.0-3).
Note: Air simultaneously continues to exit the hose
connected to the tire.
WARNING:
ONCE BEADING IS COMPLETE, IMMEDIATELY
STOP INTRODUCING AIR.
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE
AIR JET.
DANGER OF TIRE EXPLOSION
Note: For safety reasons a quick-infl ating valve preset to
4,5 bar is fi tted upstream of the pressure gauge for the
pedal-operated infl ating device.
Presetting of clamping jaws:
N.B.: Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in three different
ways (Fig. 3.0-4).
Push the lever (C) on the left side of each jaw and shift at
the same each one (0/+2"/4").
VERY IMPORTANT: LOOK FOR PROPER INSERTION
OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING JAWS
ARE MOUNTED IDENTICALLY (1 OR 2, FIG. 4.1-5).
OTHERWISE THE RIM MAY COME LOOSE AND
INJURE THE OPERATOR!
15
EN -