Publicidad
Idiomas disponibles
Idiomas disponibles
Customizing Features / Options
continued from the previous page
3. Press the PROGRAM button four times to return to
the normal run display.
CLEAN FEATURE MINUTES
The Clean / Clear Water Iron Reduction feature
(described above) may be adjusted, from 1 to 15
minutes in length. To change this cycle time, use the
UP button to increase the time, or the DOWN button
to shorten the time. The default value for this feature
is 2 minutes.
1. Press and hold the PROGRAM button until the
screen in Figure 26 is displayed. Once in this
display, press the PROGRAM button three times
and the display in Figure 28 is shown.
s
2. Press the
UP or
number of minutes.
3. Press the PROGRAM button three times to return
to the normal run display.
MAXIMUM DAYS BETWEEN
REGENERATIONS
The water softener automatically controls
regeneration frequency. This provides the greatest
operating efficiency and, under most conditions, this
feature should be left in this automatic mode.
However, you may modify this feature if you want to
force a regeneration every set number of days. For
example, if your water supply contains clear water
iron, you may want the softener to regenerate every
few days to keep the resin bed clean. The maximum
days between recharges may be set from 1 to 15
days, as follows:
WATER SOFTENER CLEANSER
The manufacturer recommends that you use
Whirlpool
WHE-WSC Water Softener Cleanser, as
®
directed, every four months.
Lift the brinewell cover and pour in the entire 16 oz.
bottle of Whirlpool
Water Softener Cleanser. Press
®
the RECHARGE button and hold for three seconds,
FIG. 28
DOWN buttons to set the
Routine Maintenance
NOTE: The softener will recharge on its own if needed,
even if it is before the set number of days.
1. Press and hold the PROGRAM button until the
screen in Figure 26 is displayed. Once in this
display, press the PROGRAM button four times
and the display in Figure 29 is shown.
2. Press the
UP or
number of days.
3. Press the PROGRAM button two times to return to
the normal time of day screen.
12 OR 24 HOUR CLOCK
At the default setting, all clock displays are shown in
12 hour time format (AM and PM). If 24 hour time
format is desired, follow the steps below:
1. Press and hold the PROGRAM button until the
screen in Figure 26 is displayed. Once in this
display, press the PROGRAM button five times and
one of the two displays in Figure 30 is shown.
2. Press the
UP or
time format.
3. Press the PROGRAM button once again, to return
to the normal time of day screen.
until "RECHARGE" begins to flash in the display.
This manual recharge will take about two hours. If
taste, odor, or discoloration are detected in the water,
manually recharge the softener again, then run a cold
water faucet immediately downstream of the softener
until water tastes, smells, and appears normal.
16
FIG. 29
s
DOWN buttons to set the
FIG. 30
s
DOWN buttons to set the
Publicidad
