Notice: When your air fryer is heated for the first time, it may emit slight smoke or
odor. This is normal with many heating appliances. This does not affect the safety of
your appliance.
Preparing for use
1. Place the appliance on a stable, horizontal and even surface.
2.Do not place the appliance on non-heat-resistant surfaces.
3.Do not fill the pot with oil or any other liquid.
4.Do not put anything on top of the appliance – the airflow will be disrupted and affects
the hot air frying result.
USING THE APPLIANCE
The oil-free can prepare a large range of ingredients.
Hot air frying
1. Connect the mains plug into an earthed wall socket.(Fig. 4).
2. Carefully pull the pot out of the air fryer
3. Place the shelf in the pot (Fig. 5). Put the ingredients on the shelf (Fig. 6).
4. Slide the pot back into the air fryer (Fig. 7).
Noting to carefully align with the guides in the body of the fryer.
Never use the pot without the basket in it.
Caution: Do not touch the pot during and some time after use, as it gets very hot.
Only hold the pot by the handle.
5. Determine the required preparation time for the ingredient ( see section 'Settings' in this
chapter).
6. Some ingredients require shaking halfway through the preparation time (see section
"Settings" in this chapter). To shake the ingredients, pull the pot out of the appliance by
the handle and shake it. Then slide the pot back into the air fryer
Tip: If you set the timer to half the preparation time, you hear the timer buzzer when you
have to shake the ingredients. However, this means that you have to set the timer again to
the remaining preparation time after shaking.
7. When you hear the timer buzzer, the set preparation time has elapsed. Pull the pot out of
the appliance.
Note: Long press the power button for 2 seconds, then you can switch off the appliance
manually.
Tip: You can adjust temperature or time according to your taste during use. Your settings
will be kept for about 60 mins after you pull the pot out of the body.
8. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pot back into the appliance and set the
timer to a few extra minutes.
9. To remove ingredients (e.g. fries), pull the pot out of the Hot-air fryer and place it on trial
framework.
Do not turn the basket upside down , as any excess oil that has collected on the
bottom of the pot will leak onto the ingredients.