Silvercrest SHMS 300 C2 Guía Breve página 10

5) Replace the mixing bowl 8 on the mixer
stand 7 .
6) Press the mixer holder release 6
swing the mixer holder 7 back downwards .
7) Place the hand element q on the mixer
holder 7 so that it firmly clicks into place .
8) Push the lid 0 into the rails on the mixer stand 7
so that it sits firmly in place .
NOTE
► If you want to add ingredients during mixing,
open the filling opening 9 on the lid 0 and
add the ingredients . Close the filling opening
9 afterwards to prevent ingredients from
spraying out!
You can use the hand mixer without the mixer
stand 7 . We recommend using the hand mixer
without the mixer stand 7 especially for small
amounts of liquid . Otherwise, the mixer cannot
reach all the liquid and it may not be properly mixed .
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials . These con-
tainers may be damaged and cause injuries .
9) Insert the plug into a mains power socket .
10) To start up the appliance, move the speed
switch 1 to the desired speed setting . You can
choose between 5 speed settings and also
use the Turbo button/ 2 (see section "Speed
levels") .
SHMS 300 C2
NOTE
► If ingredients stick to the edge of the mixing
and
bowl 8 and cannot be reached by the
kneading hooks t/whisks r, switch off the
hand mixer .
Remove the lid 0 . Use the dough scraper z to
push the stuck ingredients back into the middle
of the mixing bowl 8 . Replace the lid 0 .
Switch the hand mixer back on .
11) To remove the contents of the bowl, switch off
the hand mixer . Pull the lid 0 off to the side .
NOTE
► For safety reasons, the whisks r and knead-
ing hooks t can only be released if the
speed switch 1 is set to the position "0" .
12) Press the mixer holder release 6
the mixer holder 7 and remove the mixing bowl
8 from the mixer stand 7 . You can now re-
move the contents of the bowl .
NOTE
► If you want to remove the whisks r or knead-
ing hooks t, you must first remove the hand
element q: To do this, press the hand mixer re-
lease 5
Then press the tool-release button w to release
the whisks r or the kneading hooks t .
► For safety reasons, the whisks r and knead-
ing hooks t can only be released if the
speed switch 1 is set to the position "0" .
and remove the hand element q .
GB │ IE
, flip up
│ 7 ■