Before Using; Trial Run - Hitachi C 15FB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE USING

1. Make sure the power source is appropriate for the tool.
WARNING:
Never connect the power tool unless the available AC power source is of the same
voltage as that specified on the nameplate of the tool.
Never connect this power tool to a DC power source.
2. Make sure the trigger switch is turned OFF.
WARNING:
If the power cord is connected to the power source with the trigger switch turned
ON the power tool will start suddenly and can cause a serious accident.
3. Check the saw blade for visible defects.
Confirm that the saw blade is free of cracks or other visible damage.
4. Confirm that the saw blade is attached securely to the power tool.
Using the supplied 17 mm box wrench, tighten the bolt on the saw blade spindle to secure the saw
blade.
For details, see Fig. 24-a and Fig. 24-b in the section on "SAW BLADE MOUNTING AND DISMOUNT-
ING".
5. Check the safety cover for proper operation.
Fig. 6
WARNING:
NEVER OPERATE THE POWER TOOL if the safety cover does not function smoothly.
6. Confirm the position of the spindle lock before using the tool.
After installing the saw blade, confirm that the spindle lock has been returned to the retract position
before using the power tool (see Fig. 2).
7. Check the lower limit position of the Saw Blade.
Although it was adjusted before shipment, carefully check the height of the saw blade. Confirm that the
saw blade can be lowered 1-1/4" to 1-5/16" (32 mm to 33 mm) below the table insert. For details, see the
section on "Checking the saw blade lower limit position".
8. Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confirm that the power cord
plug fits properly in the electrical receptacle and does not fall out after it is inserted. Repair or replace
the receptacle if it is faulty.
9. Confirm the tool's power cord is not damaged.
Repair or replace the power cord if an inspection indicates that it is damaged.
AFTER CONNECTING THE POWER PLUG TO AN APPROPRIATE AC POWER SOURCE,
CHECK THE OPERATION OF THE TOOL AS FOLLOWS:

10. Trial Run

After confirming that no one is standing behind, the power tool start and confirm that no operating
abnormalities exist before attempting a cutting operation.
11. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for deflection to confirm that the blade is not notice-
ably unstable; otherwise vibrations might occur and cause an accident.
Safety cover and sub cover (A) are designed to protect the opera-
tor from coming into contact with the saw blade during operation
of the tool.
Always check that the safety cover moves smoothly and covers
the saw blade properly.
Sub Cover (A)
Safety Cover
English
11

Publicidad

Tabla de contenido
loading

Tabla de contenido