MIRKA DEROS II 325 Instrucciones De Manejo página 60

en (original)
• The tool has two speed control modes. In the default mode the speed can be adjusted linearly by changing the position
of the lever. In the other mode the speed remains fixed at the set max rpm when the tool is running. When the rpm+
and rpm– buttons are pressed simultaneously the tool toggles between the two controlling modes.
• When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
• When sanding is finished, turn off the sander by pressing the On/Off key. All LEDs are turned off except wireless indication
LED, if the tool is connected.
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to MyMirka app through which
additional tool functionality can be accessed. For more information on the app functionality and if it is available in your
country, go to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
1. Connect the power cord to mains outlet.
Press and hold the Speed+ button while switching the tool on with the On/Off button.
2.
Wireless indication LED starts blinking blue, to indicate that Bluetooth is active. The LED turns solid when connection
3.
is established.
Bluetooth is deactivated when the tool is disconnected from mains outlet.
4.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
The Bluetooth ® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Reducing vibration when sanding with pad saver or interface
When pad saver or interface is used for sanding, this set-up may increase the level of vibration. Your Mirka tool has a
feature that allowing to reduce this vibration. To reduce vibration that may occur when a pad saver or interface is used,
please follow these steps:
Disconnect power cable.
1.
2. Remove backing pad.
3. Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
Note! If the sander is used with an interface it is recommended that the speed is set to a maximum of 7,000 rpm.
1. Machine configuration out of box.
Edge protector
The edge protector is a accessory that can be attached to the machine to prolong the lifetime of the backing pad due to
the pad not being in contact with materials. Using the Edge Protector when sanding into corners and edges, the backing
pad doesn't scratch or damage adjacent surfaces.
60
Mirka® DEROS II 325, 350, 550, 625, 650, 680 & 750
®
DEROS II as follows:
2. Machine configuration for use with
pad saver or interface.
DEROS II 550, DEROS II 625, DEROS
II 650, DEROS II 750
3. Machine configuration for use with
pad saver or interface.
DEROS II 680