AENO EK2 Guia De Inicio Rapido página 5

cord to come into contact with sharp objects or hot surfaces. Do not immerse
the plug, power cord, kettle and/or power base in water or other liquids. Install
the device away from external heat sources or other electrical appliances. Do
not turn on an empty kettle. Do not open the lid of the kettle while the water
is boiling and for two minutes after boiling. Be careful when pouring hot water,
do not tilt the kettle with water too sharply. Make sure the lid is tightly closed
before lifting the kettle. Lift the kettle by the handle only. Do not pour water
below the "MIN" mark and above the "MAX" mark on the inside of the housing.
Use the device only with the supplied power base. The kettle is designed to
heat and boil water only. Use purified water to reduce scale formation. Unplug
the kettle when not in use and before cleaning. Do not use chemical and
aggressive detergents, abrasive pastes, products containing acids and solvents
or metal sponges for cleaning. Do not allow children to use and/or play with
the device. Detailed information can be found in the complete operating
manual, available for download at aeno.com/documents.
Meanings of the switch LED indicator light states
State
On
Off
Switch functions
Action
Flick down
Flick up
Preparing the device for use
Before using the device for the first time, clean it by doing the following:
1. Open the packaging and remove the device. Remove any packaging materials.
2. Place the power base on a flat, stable surface.
3. Open the lid of the kettle and fill with water up to the "MAX" mark.
4. Close the lid tightly and place the kettle on the power base.
5. Insert the plug into the socket.
aeno.com/documents
Description
The water boiling process has been started
The water boiling process is finished / was interrupted
Description
Starts the water boiling process
Interrupts the boiling process
5