AENO EK2 Guia De Inicio Rapido página 6

6. Flick the switch down: the indicator light will go on, and the water will start
to heat up.
7. Wait until the switch automatically returns to its initial position and the
indicator light goes out. The water boiling process will be finished.
8. Remove the plug from the electric socket.
9. Remove the kettle from the power base and carefully drain the water.
ATTENTION! Do not drink water obtained after the first two boilings.
10. Allow the device to cool down and repeat steps 3–8.
11. After the device has cooled down completely, wipe the exterior and interior
surfaces with a dry cloth.
Using the Device
1. Remove the kettle from the power base.
2. Open the lid and pour in the desired amount of water.
Note. Do not pour water below the "MIN" mark and above the "MAX" mark on
the inside of the housing.
3. Follow steps 4–8 of the "Preparing the device for use" section.
4. Remove the kettle from the power base and carefully pour water from it.
Note: You can interrupt the boiling process by pulling the switch up or
removing the kettle from the power base.
Cleaning and Maintenance
ATTENTION! Before cleaning, unplug the kettle and allow it to cool down.
Wipe the outside of the kettle with a soft cloth soaked in warm water or a mild
soap solution. Then wipe with a soft cloth dampened with clean water and
wipe dry.
Descaling
Frequency (when using the kettle 3–5 times a day): hard and very hard water –
once a month; medium hard or soft water – once every 2–3 months.
Anti-scale products and cleaning methods
Table vinegar
Pour 0.5 L of vinegar (6 %
or 9 %) into the kettle,
6
Citric acid
Boil 0.5 L of water. Add
25 g of citric acid and
Anti-scale product
Follow the
manufacturer's
aeno.com/documents