Covidien Kendall SCD 700 Serie Manual Del Usuario página 9

Step 2. Plug In
• Plug the Controller power cord into an AC power outlet. The blue AC Power Indicator
will illuminate.
• Do NOT turn on the Controller.
If you turn the Controller on before completing steps 3 and 4 you will see a garment
connection error. You will have to turn off the Controller and complete steps 3 and 4 to
correct the error. Refer to Section 3, Error Screens.
CAUTION
To avoid tripping hazard, do not place power cord, tubing, or Controller in walk areas.
11
NOTE
Kendall SCD 700 Series
TM
Step 3. Attach Tubing to Controller
The Controller can operate with one or two garments attached.
• Tubing should be fully unwound before connecting to Controller and garments.
• Plug the tubing set(s) into the connection point(s) on the back of the Controller.
• Route the tubing from the Controller toward your limb(s). To avoid tripping hazard,
do not place power cord, tubing, or Controller in walk areas.
Match the port on the left, marked A, with the left limb. Match the port on the
right, marked B, with the right limb.
Although not required, this matching can make it easier to troubleshoot any
problems that may occur.
Kendall SCD 700 Series
TM
NOTE
12