Publicidad
Idiomas disponibles
Idiomas disponibles
Using the Controls –
Controls a
t a glance
Getting Started
Dry er Exhaust tips
1. Add detergent and additives to the washer.
2. Load the washer.
3. Close the lid.
4. Select the appropriate cycle and options for the load.
5. Press the Cycle Selector dial.
6. The Fill indicator light will illuminate and the washer
will start to fill.
Note:
The lid must be completely closed in order
to operate the washer controls.
STEP
1
Select Water Level
Determine the selected setting based on clothes load
size. Selection should provide sufficient water to permit
clothes to circulate freely during agitation.
It may become necessary, due to bulky fabrics, to
adjust the water level after agitation begins. To adjust
the water level, turn the Infinite Water Level control to
reset and then back to the desired setting.
WATER LEVEL SETTING
Small
Medium
Large
Super
9
Not es
LOAD SIZE
1/4 - 1/3
1/3 – 1/2
1/2 – 2/3
2/3 – Full
Electronic Control Models
STEP
2
Select Wash/Rinse Temperature
Your washer gives you a choice of hot, warm or cold
water for washing and cold water or warm water
(select models) for rinsing. Use the chart below as a
guide.
Automatic Temperature Control (A.T.C.) provides
the optimal wash water temperature for cleaning. To
save energy, this washer will regulate wash water
temperatures by mixing hot and cold water to reach
the proper water temperature.
WASH/RINSE
TEMPS
Brightly colored, lightly soiled
Cold/Cold
items; washable woolens.
(select models)
These settings feature Automatic Temperature Control:
Saves energy by adding cold water
ATC Hot/Cold,
to the hot water from your water
ATC Warm/Cold
heater. Provides optimum cleaning
at lower temperatures.
May add hot water to the incoming
cold water as the washer fills. This
ATC Cold/Cold
assures that the water will be warm
enough to properly activate detergent.
LOAD TYPE
Publicidad
