cecotec FAST&FURIOUS 8050 X-TREME Manual Del Usuario página 39

temperature knob to the third position and use a dry cloth as a mat.
Never iron over zips or rivets in the cloth. This will damage the soleplate.
Warning: When ironing woolen fabrics, shining of the fabric may occur. In this case, it is
suggested to turn the article inside out and iron the reverse side.
Setting
1
2
3
Maximum
4. CLEANING AND MAINTENANCE
Before cleaning the device, disconnect it from the power outlet and allow the appliance to cool
down.
Wipe deposits on the soleplate with a damp cloth or a non-abrasive (liquid) cleaner.
Warning: Do not use chemical, steel, wooden or abrasive cleaners to scrape the soleplate.
Clean the upper part of the device with a soft damp cloth. Wipe water drops on the unit base
and the heatproof stand with a dry cloth.
If there is any fabric adhered to the soleplate, use a damp cloth with vinegar to wipe off the
soleplate.
To remove the mineral deposits gathered in the inner steam generator, follow the following
steps:
Make sure the steam station has completely cooled down before cleaning.
Remove the water tank.
Turn the steam station upside down and remove the water inlet cover. Empty the tank.
Fill the tank with clean water. Tap water may be used as long as it does not have a high content
of limescale. If it does, use 50 % tap water and 50 % low-mineral water. Makes sure water
does not overflow.
Press the water inlet cover into position and make sure it is safely fitted.
Firmly hold the steam station with both hands and shake it several times.
Turn the steam station upside down again and remove the cover. Empty all the water.
Replace the cover.
The steam station is ready for next use.
Fig.7
Warning: To avoid a risk of scald, make sure the steam generator has been cooled down
Temperature
70 ºC-120 ºC
100 ºC-160 ºC
140 ºC-210 ºC
170 ºC-225 ºC
Fabric
Acetate, elastane, polyamide,
polypropylene
Cupro, polyester, silk
Triacetate, viscose, wool
Cotton, flax
FAST&FURIOUS 8050 X-TREME
ENGLISH
39