VALBERG 6S47 D SAD929C Instrucciones De Uso página 17

B
Product usage
Warning
indicator
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise the
level of salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Without any operation in five seconds or press the Power button to end the setting mode,
the setting is memorized by the programme.
WATER HARDNESS
°dH Mmol/l
(1)
0 - 5 0 - 0.9
6 - 11 1.0 - 2.0
12 - 17 2.1 - 3.0
18 - 22 3.1 - 4.0
23 - 34 4.1 - 6.1
35 - 45 6.2 - 8.0
Rinse Aid
If the " " indicator is lit, it means the dishwasher is
low on dishwasher rinse aid and requires a refill.
Salt
If the " " indicator is lit, it means the dishwasher is
low on dishwasher salt and needs to be refilled.
Water Faucet
If the " " indicator is lit, it means the water faucet
closed.
Setting on the water
softener
(2)
1
2
3
4*
5
6
16
Digital display
stalls
H1
H2
H3
H4
H5
H6
EN
Regeneration
occurs every
X program
sequence
(3)
No regeneration
10
5
3
2
1