VALBERG 6S47 D SAD929C Instrucciones De Uso página 7

B
Product usage
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (if supplied) into the hole and pour in about 1 kg of dishwasher
salt.
3. Fill the salt container to its maximum limit with water, It is normal for a small amount of
water to come out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will turn off after the salt container has been filled with salt.
6. Immediately after filling the salt into the salt container, a washing program should be
started (We suggest to use a short program). Otherwise the filter system, pump or other
important parts of the machine may be damaged by salty water. This is out of warranty.
NOTE:
• The salt container must only be refilled when the salt warning light
control panel comes on. Depending on how well the salt dissolves, the salt
warning light may still be on even though the salt container is filled. If there is
no salt warning light in the control panel (for some models), you can estimate
when to fill the salt into the softener by the cycles that the dishwasher has run.
• If salt has spilled, run a soak or quick program to remove it.
Installation instruction
WARNING
Electrical shock hazard
• Disconnect electrical power before installing dishwasher.
• Failure to do so could result in death or electrical shock.
• The installation of the pipes and electrical equipments should be done by
professionals.
About power connection
WARNING
For personal safety:
• Do not use an extension cord or an adapter plug with this appliance.
• Do not, under any circumstances, cut or remove the earthing connection from
the power cord.
6 EN
in the