Publicidad
Idiomas disponibles
Idiomas disponibles
Remodel (Install from below) INSTALLATION STEPS:
Read the entirety of the Installation Instructions guide before beginning to install the fixture.
WARNING: Before beginning the installation, make sure all power is off, shutting power off in breaker
box to areas where downlights are to be installed is recommended
1.
Remove existing retrofit fixture and recessed housing if present or move it out of the way since it will not be needed for
installation. If a new hole is to be cut, use the provided hole template. Place template over the desired location. Trace the outer
ring with a pen or pencil (not included). Cut the opening with a hole saw (hole saw is recommended to make the precise cut
required for this installation) (see Figure1). Recommended hole diameter is 2.5".
2.
Double check and measure the ceiling hole. Make sure it is the correct size for the outside rim of the luminaire to cover the hole
while still allowing the back of luminaire to sink into the ceiling and springs to hold firmly.
3.
Open the cover of the remote driver box. Push and remove the appropriate knockout(s) on the side plate to accommodate the
type of electrical supply being used. Locate power supply leads from remote driver box and connect to power source using
poke-in connectors (provided). Connect black wire to live wire, white wire to neutral wire, and copper ground wire with ground
(as shown Figure 2) and secure using poke-in connector; Pink and Purple Wire only applies to MVOLT fixture 0-10V dimming.
Close the cover of the box.
4.
Connect the remote driver box to the trim module and tighten the nut connector by hand. Arrow on the male and female parts of
the connector between the driver and fixture cable should match. (Figure 3)
One Lithonia Way · Conyers, GA 30012 · Phone 1-(800)705-7378
Visit us at
© 2024 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
Figure 1
Figure 2
www.acuitybrands.com/juno-recessed
.
Juno Wafer 2" LED Downlight-WF2 Series
912-00497-001 REV A
DATE 01/2024
4
PAGE |
Publicidad
