Goodwe ETC Serie Guía De Instalación Rápida página 4

EN
supply power to the load. Otherwise, the risk caused is beyond the warranty of the device
manufacturer.
6. All labels and warning marks should be visible after the installation. Do not scrawl, damage,
or cover any label on the device.
7. Do not touch the running equipment to avoid being hurt as its temperature may exceed 60℃.
Do not install the equipment at a place within children's reach.
8. Unauthorized dismantling or modification may damage the equipment, the damage is not
covered under the warranty.
9. If the BACK-UP function is used to supply power to the load, make sure that the BACK-UP
terminal is properly connected to the inverter.
10. If there is any radio or wireless communication equipment below 30MHz near the inverter,
you have to:
• Install the inverter at least 30m far away from the wireless equipment.
• Add a low pass EMI filter or a multi winding ferrite core to the DC input cable or AC output
cable of the inverter.
11. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD.
Disconnect all incoming power
and turn off the product before
working on it.
Read through the guide before
working on this device.
High-temperature hazard. Do
not touch the product under
operation to avoid being burnt.
CE marking
Battery Safety:
1. The battery used with the inverter shall be approved by the inverter manufacturer. The
approved battery list can be obtained through the official website.
2. Before installations, read through the corresponding battery's User Manual to learn about
the product and the precautions. Strictly follow its requirements.
3. If the battery discharged completely, please charge it in strict accordance with the
corresponding model's User Manual.
4. The battery current may be influenced by temperature, humidity, weather conditions, etc.,
which may limit the current and affect the load capacity.
5. If the battery cannot start properly, contact the after-sales service as soon as possible.
Otherwise, the battery will be damaged permanently.
6. Measure the DC cable using the multimeter to avoid reverse polarity connection. Also, the
voltage should be under the permissible range.
7. To avoid damage the inverter, do not connect one battery pack to multi inverters.
Delayed discharge. Wait 5 minutes
after power off until the components
are completely discharged.
5min
Potential risks exist. Wear proper
PPE before any operations.
Grounding point. Indicates the
position for connecting the PE cable.
Do not dispose of the inverter
as household waste.Discard the
product in compliance with local
laws and regulations, or send it back
to the manufacturer.
02