Publicidad
ENGLISH
Spills on touch
icons
6. TROUBLESHOOTING
Problem
The induction
hob does not
turn on
The touch icons
do not work
It is difficult to
use the touch
icons
The glass is da-
maged
Some frying pans
make crackling or
popping noises
48
EVVO PLACA DE INDUCCIÓN V61
Unplug the cooking hob
from the mains.
Blot the spill.
Clean the touch control
area with a sponge or a
damp and clean cloth.
Dry the area completely
with a paper towel.
Unplug the cooking hob
from the mains.
Possible causes
There is no electricity.
The icons are locked.
There may be a slight
film of water on the but-
tons, or you may be using
your fingertip to press
the buttons.
Irregular-edged cookwa-
re.
Use of inappropriate and
abrasive scouring pads or
cleaning products.
This may be due to the
construction of your
cookware (layers of diffe-
rent metals that vibrate
differently).
The induction hob may emit an
acoustic signal and switch off, and
the icons may not work if wet. Be
sure to dry the touch icons before
switching the induction hob back
on.
Possible solution
Make sure the hob is connected
to the mains and it is on.
Check if there has been a power
failure. If the problem persists,
please contact the official EVVO
Technical Support Service.
Unlock the touch icons. Check the
instructions in the "Operation"
section.
Make sure the touch icons are dry
and press them with the base of
your finger.
Use cookware with flat and smoo-
th bases. See section on "Choo-
sing the right cookware".
See section on "Cleaning and
maintenance".
This is normal for cookware and
does not indicate a fault.
Publicidad
