Elite Xtreme XBEA20 Manual De Usuario página 44

X B E a 2 0
Keep Working
11. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface
and pull the power tool out of your control.
12. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your
clothing, pulling the accessory into yourbody.
13. Regularly clean the power tool's air vents. The motor's fan will draw the dust inside the housing and excessive accumulation
of powdered metal may cause electrical hazards.
14. Do not operate the power tool near flammable materials. Sparks could ignite these materials.
15. Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in electrocution or shock.
Kickback and RelatedWarnings
Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other accessory. Pinching or
snagging causes rapid stalling of the rotating accessory which in turn causes the uncontrolled power tool to be forced in the
direction opposite of the accessory's rotation at the point of the binding. For example, if an abrasive wheel is snagged or pinched
by the workpiece, the edge of the wheel that is entering into the pinch point can dig into the surface of the material causing the
wheel to climb out or kick out. The wheel may either jump toward or away from the operator, depending on direction of the wheel's
movement at the point of pinching. Abrasive wheels may also break under theseconditions.Kickback is the result of power tool
misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below.
1. Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces. Always use
auxiliary handle, if provided, for maximum control over kickback or torque reaction during start-up. The operator can control
torque reactions or kickback forces, if proper precautions are taken.
2. Never place your hand near the rotating accessory. Accessory may kickback over your hand.
3. Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel the tool in direction
opposite to the wheel's movement at the point of snagging.
4. Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory. Corners, sharp edges
or bouncing have a tendency to snag the rotating accessory and cause loss of control or kickback.
5. Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback and loss of control.
KEEP WORKiNG
10