Publicidad
Idiomas disponibles
Idiomas disponibles
X B E a
2 0
Keep Working
1. Inner flange 2. Spindle 3. wheel guard for grinding 4. Grinding wheel 5. Lock nut 6. Lock nut wrench 7. Shaft lock
To remove the wheel, follow the installation procedure inreverse
Installing or removing abrasive cut-off wheel
Optional accessory
NOTE: Use abrasive cut-off wheel specified in this manual.
WARNING: When using a abrasive cut-off wheel, the wheel guard for cutting must be fitted on the tool so that the closed side
of the guard always points toward the operator.
CAUTION: Make sure that the mounting part of the inner flange fits into the inner diameter of the cut-off wheel perfectly. Mounting
the inner flange on the wrong side may result in the dangerous vibration.
To install the abrasive cut-off wheel, perform the following steps:
1. Mount the inner flange onto the spindle.Make sure to fit the dented part of the inner flange onto the straight part at the bottom
of the spindle.
2
3
1
2. Fit the abrasive cut-off wheel on the inner flange.
4
1
KEEP WORKiNG
23
Publicidad
