Elite Xtreme XBEA20 Manual De Usuario página 54

X B E a 2 0
Keep Working
Turn anticlockwise to loosen the screw a little, and then pull the lever in the direction of the arrow. Mount the wheel guard with
the maximal protrusions on the wheel guard band aligned with the maximal notches on the bearing box. Then rotate the wheel
guard to such an angle that it can protect the operator according to work.
1. Wheel guard for grinding 2. Bearing box 3. Screw
4. Lever 5. Maximal protrusions 6. Maximal notches Pull the lever in direction of the arrow. Then tighten the wheel guard with
fastening the screw by turning it clockwise. Be sure to tighten the screw securely. The setting angle of the wheel guard can be
adjusted with thelever.
To remove wheel guard, follow the installation procedure inreverse
1. Screw 2. Lever
Installing or removing wheel guard for cutting
Optional accessory
WARNING: When using an abrasive cut-off wheel , the wheel guard for cutting must be fitted on the tool so that the closed side
of the guard always points toward the operator.
KEEP WORKiNG
20