Whirlpool W6 OM4 4PBS1 P Guía De Consulta Diaria página 12

REPLACING THE LAMP
5. Disconnect the oven from the power supply.
6. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
7. Reconnect the oven to the power supply.
PROBLEM
The oven is not working.
The display shows the letter "F" followed
by a number or letter.
A 6th sense cooking function ends
without displaying a countdown. Cooking
ends before the end of the countdown.
The oven does not heat up.
The function does not start.
The light switches off.
The door will not open.
PRODUCT FICHE
The product fiche with energy data of this
WWW
appliance can be downloaded from Whirlpool website
docs.whirlpool.eu
HOW TO OBTAIN THE USE AND CARE GUIDE
> Download the Use and Care Guide
WWW
from our website docs.whirlpool.eu (you can
use this QR Code), specifying the product's
commercial code.
> Alternatively, contact our Client After-sales Service.
12
POSSIBLE CAUSE
Power cut.
Disconnection from the mains.
Oven failure.
Amount of food different from the
recommended range. Door open
during cooking.
"DEMO" mode is running.
"ECO" mode is "On".
Cleaning cycle in progress.
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is speci cally
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your ngerprints could cause damage. Do not use
the oven until the light cover has been re tted.
SOLUTION
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Contact you nearest Client After-sales Service Centre and
state the number following the letter "F".
Open the door and check the doneness of food. If
necessary, complete cooking by selecting a traditional
function.
Acceed "DEMO" from "SETTINGS" and select "Off".
Acceed "ECO" from "SETTINGS" and select "Off".
Wait for the function to finish and for the oven to cool
down.
CONTACTING OUR AFTER SALES SERVICE
You can find our contact
details in the warranty
manual. When contacting
our Client After-sales
Service, please state the
codes provided on your
product's identification
plate.
XXXXXXXXXX
Model: xxxXXXXxx
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXX
XXX X X X X X XXX XX XXXX X X X