Publicidad
Idiomas disponibles
Idiomas disponibles
LIRA SLIM PLUS
8.3
CLEANING OPERATIONS
8.3.1
Brazier - brazier holder cleaning
To clean the brazier, proceed as described:
Step
Action
1
Remove the brazier and the flame baffle.
Remove the ash residues deposited in the combustion chamber and in the brazier holder.
2
Note: It is advisable to use a suitable vacuum cleaner.
Clean daily to ensure perfect combustion conditions, as the brazier holes allow
the passage of combustion air.
Also check that the combustion air passage and the internal baffle (if present) of the brazier holder are free from
combustion residues and any ash.
The brazier must rest on the brazier holder and precisely on the entire annular
band without having any air passage openings.
8.3.2
Cleaning the ash pan
To clean the ash pan, proceed as described:
Step
Action
1
Open the fire door.
2
With a suitable vacuum cleaner, vacuum the ash inside and any combustion residues.
3
After cleaning, the fire door must be closed.
The ash pan can be cleaned every 2-3 days depending on unit use.
8.3.3
Cleaning the glass
To clean the glass, proceed as described:
Step
Action
1
Open the fire door.
2
The glass can be cleaned on the outside and inside using a damp cloth and specific non-abrasive detergents.
3
The door must be closed after cleaning.
NB: When doing this, make sure the seals around the glass and the seal on the door are in good condition; failure
to check these seals can compromise the unit's operation. However, poor quality pellets can cause the glass to
blacken and/or deteriorate.
Do not turn on the unit with the GLASS cracked or damaged.
8.3.4
Cleaning the air intake pipe
Dust can accumulate inside the inlet pipe, which over time can limit the flow of combustion air: periodically, every
4 - 6 months of operation, carry out a check and, if necessary, clean the inside using suitable equipment (air blower
or suitable brushes).
8.3.5
Cleaning the room fan
Any deposits of dust on the fan blades lead to an unbalance of the impeller causing an increase in noise during
operation.
Therefore it is necessary to provide for adequate cleaning to be carried out only by an authorized service center.
EN
A73023890 - Rev 03 - 02/2024
163
Publicidad
