UFESA SF Aalborg Manual De Instrucciones página 16

SPEED button:
Push SPEED button to select MIDDLE (F2), HIGH (F3) or LOW (F1) fan speed. With each
push on SPEED button, the related symbol will flicker 3 times. Then the display will
show the room temperature.
Push + or - on the remote control to set the fan speed.
OSCILLATION button:
Push button to oscillate the fan horizontally, and the related symbol
Push it again to change the horizontal oscillation to vertical oscillation function, the
related symbol will light up. Push it again to oscillate the fan up, down, left, and right
simultaneously and the related symbols
again to stop the oscillation function and the related symbol will turn off.
Push or on the remote control to set the oscillation function.
TIMER button:
Push TIMER button to select between 00-15 hours, and the related value will flicker 3
times. And then the room temperature will be displayed.
LIGHT button (on the remote control only):
Press LIGHT button to turn on the ambient light and push it again to turn off the light.
MODE button (on the remote control only):
Push MODE button to select Natural mode (H1), Sleeping mode (H2) or Normal mode
(F1) and the related symbol will light up or turn off (only for remote control adjustment).
Natural Mode: To imitate the effect of natural wind, the fan changes the speed be-
tween low-middle-high with a specific pattern.
Sleeping mode: In this mode the speed of the fan is decreased until it reaches the
lowest speed.
Note: If no operation is performed within 180 seconds, the display screen will au-
tomatically turn off. Press any button to wake it up.
CLEANING AND MAINTENANCE
Warning: before carrying out regular cleaning operations, disconnect the plug from
the mains socket.
• To clean the appliance, use a soft, slightly damp cloth. Do not use abrasive or corro-
sive products.
• Do not immerse any part of the fan in water or any other liquid. If this accidentally
happens, under no circumstances should hands be put into the liquid. Immediately dis-
connect the plug from the mains socket. Then dry the appliance carefully and check that
all the electrical parts are dry. If in doubt, check with professional qualified technician.
• It is essential that the air inlet and air outlet holes are free of dust and fibres.
• In case of long periods of non-use, store the fan, protecting it from dust and moisture.
We recommend using the original packaging.
16
and will light up at the same time. Push it
will light up.