Sammic MO-1817S Manual De Instrucciones página 16

EN ES
SETTING UP YOUR OVEN
NAMES OF OVEN PARTS AND ACCESSORIES
Remove the oven and all materials from the carton and oven cavity. Your
oven comes with the following accessories:
Instruction Manual
A) Control panel
B) Observation window
C) Safety interlock system
D) Ceramic board
E) Filter
F) Plug
G) Scanner
Note: 1) Don't press the ceramic board forcibly.
2) Take and put the utensils gently during the
operation in order to avoid damage to the ceramic board.
3) After using, don't touch the ceramic board by
hand in order to avoid high temperature scald.
COUNTERTOP INSTALLATION
Remove all packing material and accessories.
Examine the oven for any damage such as dents or
broken door. Do not install if oven is damaged.
Cabinet: Remove any protective film found on the
microwave oven cabinet surface.
1
INSTALLATION
1. Select a level surface that provide enough open space for the intake
and/or outlet vents (Figure1).
Fig 1
12 inch (30cm)
4.0 inch (10cm)
4.0 inch (10cm)
OPEN
A 10-cm spacing should be kept between the appliance and right and
back walls, and a 30-cm spacing kept on the top. Never dismantle the
appliance's feet, nor block the air intake and exhaust opening. The
left side must be open.
1) Blocking the intake and/or outlet openings can damage the oven.
2) Place the oven as far away from radios and TV as possible.
Operation of microwave oven may cause interference to your
radio or TV reception.
3) Plug your oven into a standard household outlet. Be sure the volta-
ge and the frequency is the same as the voltage and the frequency
on the rating label.
4) Warning: The plug socket, electric appliances or the appliance
which are liable effected by heat and moisture should be kept
away from any vents on the oven.
2. Stacking and installation of the microwave oven. The maximum height
of stacking shall be two layers. Specific stacking installation is as
follows
(A) Unscrew and remove the mounting plate, and then tighten the
screws.
(B) Remove the four screws as shown in Figure.
(C) Mount the mounting plate to the lower position and fix the screws
that are just loosened.
16
- 16 -