Descargar Imprimir esta página

Sammic MO-1817S Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
6) If " " button not pressed at the last step, the program cannot
be saved but stay at previous way.
18.
Factory-default setting
In the Ready Mode, pressing " " and "0" to factory-default
setting.
1) Press " " and "0", the buzzer sounds once, and the screen will
display "CHECK".
If it is in the factory-default setting, the screen will display "11",
after three seconds, the oven turn to the ready mode Press
"
" to cancel the display ang back to ready back in the pro-
cess of display.
If not in the factory-default setting, the screen will display "00",
press " " to the factory-default setting, the screen will display
"CLEAR". the buzzer sounds once, after self-testing, the screen
will display "11" or "00".
2) If do not press " " when the screen display "00", the setting
will cancel.
Note: Be careful in the operation as it will restore all configure to
factory-default setting.
FILTER CLEANING
Filter
Filter screws
The front filter serves as the air inlet; the filter
should be cleaned on time to keep the chamber
clean.
1. Turn counterclockwise to unscrew and take
down the filter; and wash it with warm soap
water;
2. Install the filter screen Tighten clockwise the
screws to fix the filter;
3. Make sure the filter is installed before use of the
microwave oven;
4. The factory setting has the function to remind
the user of washing the filter every 30 days.
(6) Splash shield cleaning
1. Detaching: Hold the two buckle positions in front
of the splash shield with your hands (as shown
by the arrows). Exert your strength following the
direction of the arrows and pull downwards after
you have pulled out the buckles:
2. Wash the splash shield:
3. Installation: Pick up the splash shield and obli-
Caution! Make sure the
splash shield is installed
correctly before use of
the microwave oven!
23
- 23 -
quely put it into the chamber in the way that
insert the first pin at the rear into the positioning
hole on the rear plate of chamber, then push the
other side to insert all positioning pins into their
positioning holes.
EN
ES

Publicidad

loading