Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Do not exceed lowest pressure rating of
any component in system.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate pump with broken,
missing or defective parts. Replace
defective parts prior to operation.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate with leakage in system.
Disconnect air to motor.
Failure to comply may results in
serious injury.
Installation
NOTE
The following procedures consider the
pump to be installed onto a container
with a cover.
1 Install bolts that attach cover to pump.
Tighten bolts securely.
2 Place follower into container.
3 Press downward and maneuver follower
until grease appears around its edges
and center hole. Make sure all air is
removed.
4 Install pump through follower and onto
container.
5 Secure cover and pump to container.
Additional items that should be incorporated
into air piping systems are listed in
Air line components, Table 5.
Air line components
Item
Description
338862
Moisture separator/regulator and gauge combination
5608-3
Moisture separator
7608-B
Regulator and gauge
5908-3
Lubricator
1)
Although the air motor is lubricated at the factory, the life of the motor can be extended with the use of a lubricator.
Alternative accessory items
Application
Single-post hoist
Dual-post hoist
Bulk grease
1)
NPTF 1
1
/
in (e)
2
13
Alternate
installations
Pump model 7795-A5 can be mounted from
a single-post hoist, dual-post hoist, or in
bulk grease distribution systems.
When either of these type arrangements
are employed, alternate accessory items
must be purchased (→ Table 6).
1)
Followers
Adapter kit
327242
327247
327690
327247
–
–
Table 5
Table 6
Primer body
–
–
333693
1)
Publicidad
