Rothenberger RO DD AMPShare Instrucciones De Uso página 18

d) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
e) Do not use a damaged or modified battery. Damaged or modified batteries can behave
unexpectedly and lead to fires, explosions or injuries.
f) Do not expose a battery for fire or high temperatures. Fire or temperatures above 130°C
(265°F) can cause an explosion.
g) Follow all the instructions for charging and never charge the battery or the cordless
tool outside the temperature range specified in the operating instructions. Incorrect
charging or charging outside the permitted temperature range can destroy the battery and
increase the fire risk.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical re-
placement parts. This will ensure that the safety of the power tool is maintained.
b) Never service damaged batteries. All maintenance of batteries should only be carried out
by the manufacturer or authorised customer service points.
1.3 Special safety instructions
Safety information for drills and screwdrivers
Safety instructions for all operations
Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
Hold the power tool by insulated gripping surfaces, when performing an operation where
the cutting accessory or fasteners may contact hidden wiring. Cutting accessory or fasten-
ers contacting a "live" wire may make exposed metal parts of the power tool "live" and could
give the operator an electric shock.
Safety instructions when using long drill bits
Never operate at higher speed than the maximum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece, re-
sulting in personal injury.
Always start drilling at low speed and with the bit tip in contact with the workpiece. At
higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the work-
piece, resulting in personal injury.
Apply pressure only in direct line with the bit and do not apply excessive pressure. Bits
can bend causing breakage or loss of control, resulting in personal injury.
Additional safety warnings
Hold the power tool securely. When tightening and loosening screws be prepared for tempo-
rarily high torque reactions.
Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held more
secure than by hand.
Use suitable detectors to determine if there are hid-den supply lines or contact the local
utility company for assistance. Contact with electric cables can cause fire and electric shock.
Damaging gas lines can lead to explosion. Breaking water pipes causes property damage.
Always wait until the power tool has come to a complete stop before placing it down. The
application tool can jam and cause you to lose control of the power tool.
Switch the power tool off immediately if the application tool becomes blocked. Be pre-
pared for high torque reactions which cause kickback. The application tool becomes
blocked when it becomes jammed in the workpiece or when the power tool becomes over-
loaded.
In case of damage and improper use of the battery, vapours may also be emitted. Ensure
the area is well-ventilated and seek medical attention should you experience any adverse ef-
fects. The vapours may irritate the respiratory system.
Do not open the battery. There is a risk of short-circuiting.
14 ENGLISH