Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the speed:
You can adjust the speed of the power tool when it is on by pressing in the on/off switch (11) to
varying extents.
A light pressure on the on/off switch (11) results in a low rotational speed. Increased pressure on
the switch causes an increase in speed.
Preselecting torque (applies to screwdriving mode):
The torque presetting ring (3) can be used to preselect the required torque in 20 stages. Once
the set torque has been reached, the tool will stop delivering power to the application.
Mechanical gear selection:
Only operate the gear selector (5) when the power tool is not in use!
First gear:
Low speed range; for working with a large drilling diameter or for screwdriving.
Second gear:
High speed range; for working with a small drilling diameter.
Always push the gear selector switch as far as it will go. Otherwise, the power tool may
become damaged!
Temperature-dependent overload protection:
When used as intended, the power tool cannot be overloaded. In the event of overloading or the
temperature rising/falling outside the permitted operating temperature range, the speed will be
reduced. The power tool will not run at full speed again until the permitted operating temperature
has been reached.
Fully automatic spindle lock (Auto-Lock):
The drill spindle, and therefore the tool holder (1), are locked when the on/off switch (11) is not
pressed. This enables screws to be screwed in even when the battery (7) is empty and allows
the power tool to be used as a screwdriver.
Practical advice:
Only apply the power tool to the screw when the tool is switched off. Rotating application
tools can slip off!
Before screwing larger, longer screws into hard materials, it is advisable to predrill a pilot hole
with the core diameter of the thread to approx. 2/3 of the screw length.
An auxiliary tool can be used to remove the screwdriver bit or universal bit holder.
Belt clip:
You can use the belt clip (6) to hang the power tool on a belt, for example. You then have both
hands free and the power tool is always at hand.
4
Care and Maintenance
Remove the battery from the power tool before carrying out work on the power tool (e.g. mainte-
nance, changing tool, etc.). The battery should also be removed for transport and storage. There
is risk of injury from unintentionally pressing the on/off switch.
To ensure safe and efficient operation, always keep the power tool and the ventilation slots
clean.
5
Accessories
You can find suitable accessories in the main catalog or at www.rothenberger.com
6
Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using RO SERVICE+
online: + 49 (0) 61 95/ 800 8200 sf + 49 (0) 61 95/ 800 7491 service@rothenberger.com -
www.rothenberger.com
18
ENGLISH
Publicidad
