Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 27

– Check, before switching on, that
keys and adjusting tools have been
removed.
• Avoid unintentional starting
– Make sure that the switch is off when
inserting the plug into the socket.
• Use extension cables outdoors
– Only use approved and appropriately
marked extension cables outdoors.
• Pay attention at all times
– Pay attention to what you are doing.
Work using common sense. Do not
use the power tool if you cannot con-
centrate.
• Check the power tool for possi-
ble damage
– Before further use of the power tool,
safety devices or slightly damaged
parts must be carefully examined in
respect of their proper and intended
function.
– Check whether the moving parts
are working properly and are not
becoming jammed or whether parts
are damaged. All parts must be cor-
rectly fi tted and satisfy all conditions
to ensure the proper operation of the
power tool.
– Damaged safety equipment and parts
must be repaired properly or replaced
by an authorised specialist workshop
unless otherwise indicated in the op-
erating instructions.
– Damaged switches must be replaced
at a customer service workshop.
– Do not use power tools if the switch
cannot be turned on and off.
• CAUTION!
– The use of other bits and other acces-
sories can result in a risk of personal
injury.
• Have your power tool be re-
paired by a qualifi ed electrician
– This power tool complies with the
relevant safety regulations. Repairs
may only be performed by a qualifi ed
electrician, using original spare parts;
otherwise accidents involving the user
may result.
Service:
• Have your power tool repaired
only by qualifi ed specialists and
only with original spare parts.
This will ensure that the power tool re-
mains safe.
Safety information for
surface planers and
thicknessers
• Check that the machine is in a
fault-free condition before use.
• Only use well-sharpened and
well-maintained blades.
• Only use blades that are de-
signed for this machine.
• When working, completely
cover the planer blade with the
blade cover at the points where
you are not planing.
• Wear personal protective equip-
ment when working.
Wear hearing protection to reduce
the risk of becoming hard of hearing.
Wear respiratory protection to re-
duce the risk of inhaling harmful dust.
• Wear gloves when handling the
blade shaft and when working
with rough materials. This reduces
the risk of injury from sharp edges.
• Do not carry out the following
work as this may cause injury:
- Insertion work, i.e. any machining
that does not extend over the entire
length of the workpiece;
- Do not create indentations, tenons
or recesses with the device;
GB MT
27