Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 35

Troubleshooting
Problem Possible cause
Overload protection has
responded
No mains power supply
Main circuit breaker is
Machine does
tripped
not start
On switch (9)/
Off switch (10) is broken
Defective motor
Planer blade blunt
Device stops
Too much chip removal
Planed surface Workpiece to be machined
too rough too wet
Remedy
Press the overload switch (8) (reset), then
press the On switch (9)
Check the socket, mains supply cable,
cord, mains plug; if necessary, have them
repaired by a qualifi ed electrician. Check
the main fuse.
Repair by Customer Care
Repair by Customer Care
Replace planer blades
Reduce chip removal
Dry the workpiece
GB MT
35