Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 30

GB MT
be cut. This information can be found
in the operating instructions of the ex-
ternal device.
The adapter for external dust ex-
traction (16 a) can be used if the
external dust extraction cannot be con-
nected to the collection container (16)
due to its diameter.
To dismantle, loosen the two small
screws (22). Then pull the latches (21) out
of the recesses (13) on the right and left of
the discharge table (14) and remove the
collection container (16).
Checks before putting
into operation
Before putting into operation, check:
- the planer blade
- the anti-kickback claws
- the functioning of the On/Off switch
- the blade brake
If any of these checks reveal damage or
improper operation, do not operate the
machine.
Checking the switch and
blade brake
On/Off switch
1. Turn the machine on using the On
switch (9) and allow it to reach full
speed.
2. Turn the machine off using the Off
switch (10). The blade must come to a
standstill within 3.5 seconds. If this is
not the case, please contact the service
centre.
30
Checking the anti-
kickback claws
Carry out a visual inspection of the an-
ti-kickback claws (24). The anti-kickback
claws must not have any visible defects
and they must all hang evenly in a row.
Do not operate the machine if the anti-kick-
back claws are damaged. Contact the
service centre.
1. Set the planing table (23) to the lowest
position.
2. Perform the visual inspection.
General working
instructions
• Secure a long workpiece from tipping
by using a roller table or roller block.
There must be one support in front of
the feed table and one behind the dis-
charge table. The height of the support
must be set so that the workpiece rests
horizontally on the feed table and can
be carried horizontally from the dis-
charge table.
• Do not machine splintering material or
material which may have hidden metal
parts. Splintering material can cause
injury to the user. Metal parts that come
into contact with the blade can cause
the workpiece to break apart, which
can also lead to injuries.
• Wood that has lots of knots and knot-
holes can also cause the workpiece
to break apart. Do not machine this
wood.
• Do not stand directly in front of the ma-
chine during operation and stand on
one side.
• If the blade shaft blocks during opera-
tion, switch off the machine and discon-
nect the mains plug.